Duct Ventilation

If you are interested in a convenient solution to your home cooling needs, and you want one that is as cost-effective as possible, you may want to consider the option of going for duct ventilation. An effective and affordable solution to most home and workplace cooling requirements, duct ventilation may help make your space more comfortable while keeping your costs well within budget.

Measuring a duct ventilation system

The most basic design of duct ventilation involves the use of right-angled metal sheets. This device is basically intended to contain and direct the flow of air. One key distinction is that the right angle design of duct ventilation results in either of two forms:
In order to make an accurate calculation of the duct size, you will have to figure out whether you want a two-dimensional face or a three-dimensional tube. The next step would then be to make a measurement of the duct ventilation dimension and multiply the results. To do that, you will first have to determine where the start and the end of the duct measuring points lie. After marking these off with a pen, you will be able to measure the height and length, plus the depth if you are going for a three dimensional design.

Keep in mind that a two-dimensional duct ventilation system will result in either an opening or a vent. By multiplying the height and length, you will get the surface area of the duct.

For three-dimensional ducts, you will need to multiply the height, length and depth. This will result in an area measurable in cubic inches.

Installing duct ventilation

In many ways, installing duct ventilation is pretty much the same for different applications. Installing duct ventilation for a bathroom fan food for instance is pretty much the same as installing duct ventilation for a dryer. The steps involved are as follows:

Tips on duct ventilation installation

The best place to install your duct ventilation is an area with as few bends as possible. Keep in mind that with every turn of the duct, air flow resistance will increase, and the effectiveness of your system will be reduced more with sharp turns as compared to slight curves.

You will also want to begin cutting the hole from the outside, starting off on the pilot hole’s exit point. This will give you a more accurate starting point from which you will base your measurements. As you can see, duct ventilation installment can be quite a complicated task, with numerous specific steps involved. If all this seems too much for you to handle, it may be best to seek the assistance of a professional.

Back to Top